Machining time
Owing to the high feeds of the WTX – Change Feed, the machining time has been significantly reduced. A mere 41 minutes was required for these 400 holes to be produced in the practical test.
Material: 42CrMo4 | Diameter: 18 mm | Hole depth: 90 mm
| Application data | WTX-Change Feed | Competitor 1 & 2 Two fluted exchangeable head system |
|---|---|---|
| vc in m/min | 90 | 110 |
| f in mm/rev | 0.55 | 0.34 |
| vf in mm/min | 876 (+33%) | 662 |
Machining time
Owing to the high feeds of the WTX – Change Feed, the machining time has been significantly reduced. A mere 41 minutes was required for these 400 holes to be produced in the practical test.
End of service life after 1611 holes
End of service life after 988 holes
End of service life after 800 holes